IM 934-2 Applied PDAA/PDHA / Page 15 of 44
Installation of Basic Wall Sleeve
Figure 20. Panel wall construction with cord connection
3"Min. (76mm)
Conduit
Floor
Receptacle
(by others)
17"
(432mm)
8
1
/
4
"
(209mm)
16"
(406mm)
Room
Cabinet
Note: Standard subbase is available in 3" or 4"
(76 mm or 102 mm) height. Leveling legs
provide adjustment of 1" (25 mm).
Figure 19. Panel wall construction with standard electrical
subbase
17"
(432mm)
8
1
/
4
"
(209mm)
16"
(406mm)
Power Supply Connect
(Alternate Entry)
See Note
Room
Cabinet
Figure 21. Panel wall installation with hydronic subbase
Minimum
2 Supports
(field supplied)
Hydronic
Heating
Coil
Leveling Legs with 1" Adjustment
Caulk
Perimeter
both Indoors
& Outdoors
Outside
Louver
13
3
/
4
"
(349mm)
Wall Sleeve
Subbase
Side
Channel
Power Supply Connect
(Alternate Entry)
Caulk
Perimeter
both Indoors
& Outdoors
Outside
Louver
8
1
/
4
"
(209mm)
13
3
/
4
"
(349mm)
16"
(406mm)
Wall Sleeve
Room
Cabinet
17"
(432mm)
8
1
/
4
"
(209mm)
Louver Frame
(see page 11 for details)
Electrical
Subbase
Subbase Side Channel
Gasket
& Caulk
Perimeter
Outside
Louver
13
3
/
4
"
(349mm)
Wall Sleeve
Attaching Wall Sleeve to Subbase
1. Where a subbase is used, secure wall sleeve to
subbase with clips provided.
2. Caulk the wall sleeve to the wall opening on both
the inside and outside perimeter. Be careful not to
plug the weep holes. Caulking should be resilient,
nonhardening type such as silicone.
3. Secure the two sections by installing the clip
screws supplied with the hardware bag.
4. Caulk indoor/outdoor perimeter of wall sleeve
with resilient caulk such as silicone.
5. Finish any uncompleted electrical and/or plumbing
connections.
Floor
Louver Frame
(see page 11 for details)
Louver Frame
(see page 11 for details)
5. Recess the wall sleeve so that the louver is flush
with the exterior of the building.
6. Level wall sleeve left to right and pitch 1/4" front
to back to the outside and secure by anchoring
with appropriate fasteners or drill additional holes
as required to secure firmly. Refer to Anchoring
The Wall Sleeve instructions on
page 13.
CAUTION
DO NOT drill holes in the bottom of the wall sleeve as it
will cause leaks.
7. Where a subbase is used, secure wall sleeve to
subbase with clips provided.
8. Caulk the wall sleeve to the wall opening on both
the inside and outside perimeter. Be careful not
to
plug the weep holes. Caulking should be resilient,
nonhardening type such as silicone.
