User Manual
7
“Hold Until”
& “
”
display and temperature value flashing. Press
or
can
change the value, and press
F
to save the setting. Then days value flashing, users can
choose from 1-365 days by pressing
or
;
Press
can set system state;
Press
can set fan mode.
Override temperature setting
During any Schedule period, press
or
can enter an interface for temperature setting.
Press
or
to change setting temperature, and press
F
to save the change. The changed setting
only valid in the current Schedule period, device will follow the original schedule in next period.
Filter cleaning reminder
“
”
will flash on the screen to remind users of cleaning furnace filter, and 90 calendar days
are the default timing. In
Schedule
mode, to press
for 3 sec, “
” will disappear from
screen.
Sensor error
If “
FF
” flashes at temperature display area, it means the temp. sensor is out of
work(short-circuit or broken-circuit), all the outputs will be forced close, and only back to normal
work until the sensor circuit is normal again.
Z-Wave operation
Adding & Removing of Z-Wave network
In normal display, press & hold
to enter interface for adding or removing of Z-Wave
network. Before device added into network, “- - -” will display on the screen. Then press
once,
device will enter learning mode to get a node ID. If adding is success, a node ID will display on
the screen in a few seconds.
A node ID can always inform us whether the device is in the network or not.
After adding, press & hold
will return to
normal display. Now the device is ready to be operated
by controller/ gateway in Z-Wave network.
Note: Follow the same steps to remove the device from the network.
Association Group
Thermostat supports 1 association group (0x01), which can include only one Node ID. A
gateway is suggested to associate with this group. Then if any changes happen, such as:
temperature, working mode, fan state etc., the thermostat will report to this associated device
(gateway).
AG
identifier
Max
Node ID
Command Classes
Trigger situation
0x01
1
COMMAND_CLASS_SENSOR_MULTILEVEL_V5,
SENSOR_MULTILEVEL_REPORT_V5
When
temperature
change >0.5
℃
