www.mcohome.com User Manual
MCOHome Technology Co., Ltd
4
0x0E and set value
≠
0;
15,
Humidity IntervalReport
Timer set value: 0x0F
and set value
≠
0;
16,
VOC IntervalReport
Timer set value: 0x10 and
set value
≠
0;
17,
Illumination IntervalReport
Timer set value:
0x11 and set value
≠
0;
18,
Noise IntervalReport
Timer set value: 0x12 and
set value
≠
0;
COMMAND_CLASS
_DEVICE_RESET_L
OCALLY,
DEVICE_RESET_LO
CALLY_NOTIFICAT
ION
Factory setting restored
Command Class supported by the device:
( Supports S2 unauthenticated level)
COMMAND_CLASS_VERSION,
COMMAND_CLASS_MANUFACTURER_SPECIFIC,
COMMAND_CLASS_DEVICE_RESET_LOCALLY,
COMMAND_CLASS_POWERLEVEL,
COMMAND_CLASS_ASSOCIATION,
COMMAND_CLASS_ASSOCIATION_GRP_INFO,
COMMAND_CLASS_CONFIGURATION,
COMMAND_CLASS_SENSOR_MULTILEVEL
，
COMMAND_CLASS_FIRMWARE_UPDATE_MD
Command Class supported by the device:
(Not supports S2)
COMMAND_CLASS_ZWAVEPLUS_INFO,
COMMAND_CLASS_TRANSPORT_SERVICE_V2,
COMMAND_CLASS_SECURITY_2,
COMMAND_CLASS_SUPERVISION
Restore Factory Setting
1, Press & hold F1 to enter Z-Wave setting interface, then press & hold F1 again to enter parameters
setting interface;
2, Press & hold F2 to enter setting interface and select “default”;
3, Click F2 3 times and displays “OFF”-->“ON”-->“OK”-->“OFF”, factory setting is restored.
Data Calibration
Hold F1 to choose interface for data calibration. Then hold F2 to switch among the sensors.
Choose one and click F2, F1 to change the data. After finished, hold F1 can return data detecting
interface.
