www.mcohome.com User Manual
MCOHome Technology Co., Ltd
2
Installation &Wiring
Location:
Device is suggested to be installed indoor, a place with around 1.5m height above the floor where
represents the average CO2 concentration. It should be away from direct sunlight, any cover, or any
heat source, to avoid false signal for temperature control.
Notice!
1. Device must be wall-mounted vertically. Do not lay it flat
or upside down while working.
2. Do not mounted it in a wind gap, or cover its bottom,
which may affect the detected data.
Step 1:
Remove the steel frame from the backside of the device, and then fix it onto the installation
box with 2 screws.
Step 2:
Wire the adaptor.
Step 3:
Put the device back onto the steel frame, it will attach with the frame firmly by built-in
magnets.
Step 4:
Check the installation and power, the device is ready for work.
Operation
Power on/ power off
Wire the adaptor and the device is powered on. It will display all detected information by the sensors.
Display interface
Hold Key F1 can switch among the following 4 display interfaces:
1. Data detecting: display all sensors’ data
2. Network: Z-Wave Add/Remove
3. Data calibration: to calibrate the detected data manually
4. Local time setting
Z-Wave Operation
Note: A Security Enabled Z-Wave Controller must be used in order to fully utilize the product.
Add &Remove Z-Wave network
Activate Add/Remove mode in the gateway. When device is powered on, hold F1 to choose
interface for Add or Remove Z-Wave network.
Click F2 five times until
turns blue.
