McIntosh MCD 7009, Руководство пользователя

Страница: 6 / 25

READ
BEFORE
OPERATING
TRANSPORT FIXING (LOCKING) SCREW
A transport FIXING or locking screw is provided to protect the MCD7009 Laser pickup
mechanism from shocks and movement during transit or shipping. Access the fixing screw from
the bottom panel of the player.
RELEASE THE FIXING SCREW BEFORE OPERATING
1. Carefully place the player, upside down, on a firm surface with the bottom panel facing up.
2. Insert a 3/16 inch flat blade screwdriver into the fixing screw slot and turn the screw to the
FREE position, (approximately 45° rotation from LOCK).
TO TRANSPORT OR SHIP THE PLAYER
1 . Open the disc drawer to make sure no disc is loaded.
2. Carefully place the player, upside down, on a firm surface with the bottom panel facing up.
3. Insert a 3/16 inch flat blade screwdriver into the fixing screw slot and turn the screw to the
LOCK position.
HOW TO
INSTALL
BATTERIES
IN THE
REMOTE
CONTROLLER
Slide open the battery compartment. Insert two type AAA batteries into the compartment,
making sure to observe the battery polarities indicated in the battery compartment.
When the batteries are nearing exhaustion, the effective range of the remote controller
decreases, and MAY even fail to operate. In this case, replace both batteries with fresh ones.
NOTE:
1. Do not mix old and new batteries. Use ONLY batteries that are new.
2. Make sure both batteries are of the same type and identical.
3. To prevent damage caused by possible battery leakage, remove the batteries from
the remote controller if it is not going to be used for an extended period of time.
4. Never dismantle batteries of dispose of them in a fire, as they may explode. Dispose
of old batteries in an approved method for proper safety.
HOW TO
INSTALL THE
MCD7009
The MCD7009 can be placed upright on a table or shelf, standing on its own plastic feet.
It can also be installed in an optional Mclntosh L72 cabinet.
The MCD7009 can also be custom installed in a piece of furniture or cabinet of your choice.
The required panel cutout and unit dimensions are shown on a page further back in this manual.
Always provide adequate ventilation for your MCD7009, even though it developes very little
heat. Cool operation insures the longest possible operating life for any electronic instrument.
Do not install your MCD7009 directly above a heat generating component such as a high
powered amplifier. In a system stack, the power amplifier should always be at the top. If all
the components are installed in a single cabinet, a quiet running ventilation fan can be a definite
asset in maintaining all the system components at the coolest possible temperatures.
A custom cabinet installation should allow the following recommended minimum spacing dimen-
sions for cool operation. Allow at least 1-1/2 inches (3.8cm) above the unit so airflow is not
obstructed. Allow 17 inches (43.2cm) depth behind the mounting panel, which includes clearance
for connectors. Allow 1-1/8 inches (2.9cm) in front of the mounting panel for knob clearance.
6