McGREGOR MET3525, Оригинальное руководство пользователя

Страница: 15 / 20

Customer helpline 0345 605 2065
15
6. WHEN REFITTING THE SPOOL CAP.
Keep all areas of the cap and spool holder clean.
Refit the cap, pressing firmly down towards the spool holder to ensure cap is fully located.
Check that the cap is correctly fitted by trying to remove it without depressing the two latches.
7. TO REPLACE CUT LINE.
For your convenience it is recommended you buy spool and line complete.
--TO FIT SPOOL AND LINE COMPLETE:
1) Remove old spool.
2) Place new spool into cutting head. Release one line from cleat and feed line through eyelet.
3) Repeat for second line.
4) Refit the cap.
--TO FIT NYLON LINE ONLY:
WARNING!
Your trimmer is designed to use only line with a maximum diameter of 1.65
mm.
IMPORTANT - ALWAYS WIND THE LINE ONTO THE UPPER SECTION OF THE SPOOL FIRST.
1) Take two lines of approximately 3m (350W) / 5m (450W/600W) (Fig. N1).
2) Insert 15mm of line into one of the holes in the upper section of the spool and wind line in the direction
of the arrows on the top of the spool (Fig. N2).
3) Leave approximately 100mm of line unwound and place into cleat (Fig. N3).
4) Repeat on lower section of spool with another line (Fig. N4).
5) Then fit spool as described in “TO FIT SPOOL AND LINE COMPLETE”.
Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the
efficiency of the automatic line feed.
Operate
Operating instructions
3m (350W) / 5m (450W/600W)
N1 N2
N3 N4