McElroy LineTamer, Руководство оператора

Страница: 22 / 34

5 - 1
Pulling Force Limitations
When determining the amount of pulling force required through
the LineTamer, consideration must be given to the amount of drag
on the pipe. The amount of drag can be negligible or more than
the safe pulling strength of the pipe, depending on the terrain
and conditions at the job site.
Nominal pulling force through LineTamer.
3" pipe = 1,250 lbs
4" pipe = 1,800 lbs
5" pipe = 2,000 lbs
6" pipe = 2,400 lbs
Total Force = N Friction
NOTICE:
Total pulling force should never exceed the pipe
manufacturer's safe pulling strength. Exceeding these pulling
forces can damage both pipe and equipment. It may be
necessary to include a force monitoring device or a fusible
link to ensure safe pulling forces are maintained. Slings
and ropes should be of a load rating in excess of the loads
noted above. Do not exceed the rated loads of any pulling
assembly.
PH02853-5-15-07
PH00
49
4-9-1-9
5
Operation
Read and Understand
Do not operate this equipment until you have carefully read,
and understand all the sections of this manual, and all other
equipment manuals that will be used with it.
Your safety and the safety of others depends upon care and
judgment in the operation of this equipment.
Follow all applicable federal, state, local, and industry specific
regulations.
McElroy Manufacturing, Inc. cannot anticipate every possible
circumstance that might involve a potential hazard. The warnings
in this manual and on the machine are therefore not all inclusive.
You must satisfy yourself that a procedure, tool, work method, or
operating technique is safe for you and others. You should also
ensure that the machine will not be damaged or made unsafe by
the method of operation or maintenance you choose.
TX02946-4-15-09
WR000
52
-12
-1-9
2