McElroy Datalogger 4, Руководство оператора Оригинальные инструкции по эксплуатации

Страница: 15 / 40

3 - 5
Operation
Setup to Log a Joint (cont’d)
Measure the heater temperature using a user provided
pyrometer.
Press the
Up/Down keys to change heater temperature reading
based on the temperature measured.
When the reading is below the specification lower limit,
the background turns blue indicating temperature too low.
When the reading is above the specification upper limit, the
background turns red indicating temperature too high.
Tap
Next >> to get ready to log a joint.
Make sure pipe ends are properly faced and
heater is securely placed in the fusion machine
between two pipe ends.
Press the
Right Soft Key
then
Enter
or tap
Log...
and then
Start
to begin logging then close the
carriage to heat pipe.
If necessary, press << Back to review or change settings on previous screens
or tap Cancel to go back to the main DataLogger screen.
While logging a joint, the number of data points logged is
displayed, along with the elapsed time, the current pressure
reading, the various pressures, times, bead size, and open/
close time.
A stop watch at the lower left corner can be used to time the
various fusion cycles. Pressing the
Left Soft Key or tapping Reset
SW resets the stopwatch count.
At the end of the fusion, press the Right Soft Key then Enter or tap Stop then
Yes to stop logging.
PH04619-2-13-11
PH04984-11-14-13
PH04982-11-14-13