McCall
Serial Number .......................................................................3
Receiving And Inspecting The Equipment ............................3
Model Numbers ....................................................................4
Introduction ..........................................................................5
Specifications .................................................................... 6-7
Installation ........................................................................ 8-9
Electronic Temperature Control Operation ..........................10
Heated Cabinet Operation ...................................................11
Maintenance .................................................................. 12-13
Wiring Diagrams ........................................................... 14-20
Compressor Diagrams ........................................................21
Replacement Parts ........................................................ 22-24
Standard Labor Guidelines ..................................................25
Standard One Year Warranty ...............................................26
Additional Three Year Warranty ..........................................27
The serial number is on the identification plate that also
includes the model number. A typical identification plate
is shown below. On refrigeration and freezer unit the
identification plate is located inside the right most door near
the top front corner of the right interior wall. On heated units,
the identification plate is located in the shroud area on the
right side panel.
Always have the serial number of your unit available
when calling for parts or service. A complete list of
authorized McCall parts depots can be found at www.
mccallrefrigeration.com.
©2010 McCall. All rights reserved. Reproduction without written permission
is prohibited.
Contents
Serial Number Location
Even though most equipment is shipped crated, care should be
taken during unloading so the equipment is not damaged while
being moved into the building.
1. Visually inspect the exterior of the package an skid or
container. Any damage should be noted and reported to the
delivering carrier immediately.
2. If damaged, open and inspect the contents with the carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment notify
the carrier. Notification should be made verbally as well as
in written form.
4. Request an inspection of the concealed equipment.
This should be done within 10 days from receipt of the
equipment.
5. Check the lower portion of the unit to be sure legs or casters
are not bent.
6. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines are
secure and base is still intact.
7. Freight carriers can supply the necessary forms upon
request.
8. Retain all crating material until an inspection has been made
or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate. Remove
the front of the crate material, use of some tools will be required.
If the unit is on legs remove the top of the crate as well and lift
the unit off the skid. If the unit is on casters it can be "rolled" off
the skid.
Receiving And Inspecting The Equipment
Covington, Tennessee
Model: MCCR1-S Serial #: 0801152000599
Elec.Req.: 115V 60Hz 1Ph Ampacity: 6.8
System 1 System 2
Refrigerant Type: R404A
Refrigerant Amount: 12.5ozs.
Design Pressures:
High Side: 450
Low Side: 150
For Parts or Service Please Call:
1-800-733-8829
