M300DP L Series Expansion I/O Module – Installation / User Manual
16
Copyright 2016 MBW Technologies, LLC All Rights Reserved
Activating AutoStart
To activate the Auto Start Sequence:
•
Enable Auto Start mode
•
Configure start and stop DI’s and Throttle profile.
•
Set the keyswitch is in the “Auto” position
•
Activate the DI1 or DI2 inputs configured for Start.
Enable Auto Start Mode
To use the Auto Start feature the M300DP Mode must be set to A/S. See
the section on M300 Setup.
Set the Keyswitch in the “Auto” Position
When the ignition switch is placed in the “Auto”
position (keyswitch in a fully counter-clockwise
position) an ALERT will be displayed on the
main engine display. This window will display for
approximately 1 minute. The system will then
enter a power save mode, waiting for the
AutoStart input to activate.
NOTE: If the ignition switch is in the “ON” position the AutoStart feature
will not activate.
Activating the AutoStart input
There are two discrete inputs, DI1 and DI2,
which may be used to initiate an Auto Start
sequence. See the Installation section of this
manual for more information.
Selecting “A/S” enables
the AutoStart Mode
Note: A/S is not activated until
key switch is in Auto Position.
M300DP L Series Expansion I/O Module – Installation / User Manual
Copyright 2016 MBW Technologies, LLC All Rights Reserved
21
Engine Connector
The engine connector is labeled “Engine” and must be modified to support
the Auto Start module. This connector mates directly to the on-engine
harness connector.
Table 4. Engine Connector Pin Definitions
Signal
PIN
Number
Engine Harness
Connector – P2
Contact
Size
Wire
Color
Alarm A
M300DP – Alarm
(Switch Closure to
ground LO-2 Amp Max)
16
White/
Blue
B+
B
B (10A)
12
Red
AI1 C M300DP
AI1 16
Orange
Start D
Starter
(30) 12
Red/Black
Ground E
Ground
12
Black
Ignition
Out
G ECU
Power
(Ignition)
12 Violet
DI2 H M300DP
DI2 16
White
Controller
Power
J
ECU Key On
16
Purple
DI1 K M300DP
DI1
16
White/Blue
AI2 L M300DP
AI2
16
Green/
Black
DI
Common
M
M300DP DI Common
16
Black
Fuel N Fuel
Sender 16
Green/
Black
Oil Press
P
Oil Press Sender
16
Orange
Charge In
R
Charge Lamp
16
Dark Green
CAN Lo
U
CAN Low (twisted pair)
16
Light Green
CAN Hi
V
CAN High (twisted pair)
16
Yellow
Shutdown X External
Engine
Stop
16 Blue
No
Connection
A, F,H,K,L,M,
S,T,W
.
