MBM FGMD107, Инструкции по установке, эксплуатации и обслуживанию

Страница: 28 / 31

- 28 -
6.11 MESSAGES AND ALARMS
Service messages
door : door open
Cont : continuous operation
Hold flashing: waiting to hold
Hold steady: holding in process
End : cooking has ended.
Alarm messages
P1 no : Chamber temperature sensor broken or disconnected.
P2 no : Core probe broken or disconnected (it is still possible to continue using the oven without the core probe).
IMPORTANT: In the case of the last two messages, it is recommended to call a technician to restore normal conditions.
Flam : This alarm is activated when the flame control of the burner fails to detect a flame even though
the thermostat is demanding heat and the gas valve is open.
This occurs, for instance, when:
- Phase and neutral have been swapped over.
- No gas in the distribution network.
- The gas shut-off valve upstream from the oven is closed.
- When the oven has been hooked up with the distribution network and the pipes are still full of air.
- When a fault occurs in the oven system.
The alarm is signalled as follows:
- The time display shows “Flam”.
- A sound is emitted.
- Oven operation is shut down.
To restore correct oven operation, you need only:
a) Quickly check for gas in the network and see whether polarity has been reversed.
b) Press the clock button (10) to cancel the alarm.
c) Set cooking time again.
7. CLEANING AND MAINTENANCE
7.1 CLEANING
CAUTION:
Never wash the outside of the oven with direct or high-pressure jets of water as this would damage the electric components
inside.
The oven needs cleaning every day as a matter of hygiene and to prevent its operation getting impaired over time.
7.1.1 CLEANING AFTER COOKING AND AT THE END OF THE DAY
Use a specific degreasing product to clean the oven (do not use corrosive or chlorine-based detergents). It is recommended to
follow the detergent manufacturer’s directions.
1) Carry out the cleaning program as described in par. 6.5.
2) Then open the oven and wipe it with a damp cloth
or dry it with hot air at 100°C.
3) Take out the filter and the removable parts and wash them
fully open.
4) Rinse the oven and accessories with water, possibly
using the external handshower (optional on all
versions).
5) Dust the door gasket regularly with talcum powder,
at least once a week.
6) See that the outlet is cleaned regularly and
check it is clear.
FGMD207/FGMD207SC