CORONA LINE
6
“In- / In+”
activates the desired input channel including the inputs of the mbl C31. In case a digital input of the mbl C31 is
selected, no functions of the CD player are available.
3.1 Menu
Within the menu two control buttons, “
“ and “
“ on the right side, are used to move the cursor (*), “Select” enters the
chosen menu point, “Exit” leaves it.
3.2 Input Setup
Use the control buttons “
“ and “
“ to navigate. The buttons “Enable“ and “Disable“ activate or deactivate the input
channels which shall be shown in the standard display. When the little square next to the input name shows a tick, the
input channel is activated. It is not possible to deactivate “CD1”. When the new setting is complete, you leave the screen
via “Exit”, then another screen shows up. “Save” saves the new setting, “Discard” rejects it and “Cancel” brings you back
to the last shown screen where you can make further alterations.
3.3 C31 Input Mapping
Here you can assign the input channel where you want to connect the mbl C31. Default setting is “CD1”, you may choose
“CD2” or “SYM”, the symmetrical XLR input, as well. When the new setting is complete, you leave the screen via “Exit”,
then another screen shows up. “Save” saves the new input setting, “Discard” rejects it and “Cancel” brings you back to
the last shown screen where you can choose another input.
3.4 Input Name
At this point you can rename input channels. The character set is capital and small letters, ciphers 0…9, furthermore -/:
and a blank. The new name is shown in the standard display, but not within the ”Input Setup”, where the factory default
name remains. The maximum length of the new name is 8 characters. The new name is generated by tripping one of the
two control buttons „
“ / „
“ until the desired character is shown. After a pause of a second the question mark moves
one character to the right, and the procedure starts over. In case of a mistake the last shown character can be erased
by pressing the backspace button (arrow to the left). When the new name is complete, you leave the screen via “Exit and
then another screen shows up. “Save” saves the new name, “Discard” rejects it and you get back to the menu. “Cancel”
brings you back to the last shown screen where you can continue to change the input name.
3.5 Volume Cut
You can choose the maximum volume setting when the device is switched on. In case the device has been switched off
with the volume adjusted beyond this level, the volume is reset to the chosen volume while the device is being switched
on. When the new maximum setting is chosen, you leave the screen via “Exit”, then another screen shows up. “Save”
saves the new setting, “Discard” rejects it and you return to the menu. “Cancel” brings you back to the last shown screen
where you can choose a new maximum value.
