CORONA LINE
4
1. Unpacking
Included in the packing of your MBL Corona Line device you will find:
•
A power supply cable
•
A system remote control*
•
White gloves
* the remote control is not included in the packing for the mbl C21 Stereo Power Amplifier nor the mbl C15 Mono Power
Amplifier.
1.1 What you still require
To connect the components of your Corona Line stereo system, you will need the following cables:
•
Audio connection cable
•
Loudspeaker cable
•
RJ45 patch cable
Your dealer will gladly advise you on the choice of the best audio cable. Please also read the “5. Wiring Set-Ups” a little
further down in this document.
For wiring the MBL SmartLink busses, you can use standard RJ45 patch cable of the type used for networking computers.
We recommend UTP – unshielded category 6 (CAT 6) cable.
2. General Functions
2.1 Switching the device on and off
IMPORTANT NOTICE:
Before you switch on the device, make sure that it is compliant with the voltage requirements of
your country. Voltage requirements are given on the rear panel of the device.
Always make sure that the power switch on the rear panel of the device is fully switched off before adding or removing
connections.
Once all the wiring has been properly connected, you can switch on the device by turning on the “Power” switch (on the
rear panel).
2.2 MBL SmartLink
All the components of the MBL Corona Line can be connected to one another using MBL
SmartLink cable. This enables interconnected components to exchange various pieces of
information. With MBL SmartLink cable, operation of the “Standby” and “Display Bright-
ness” functions applies simultaneously to all devices and there is synchronisation of the
selected input source between the CD player and the preamplifier or power amplifier.
