7–15
If Trouble Arises
Flat Tyre
NOTE
Check the tyre in
À
ation pressure
label (driver's door frame) for the
correct tyre in
À
ation pressure.
Do not use the compressor for longer
than 10 minutes because using the
compressor for long periods could
damage it.
If the tyre does not in
À
ate, repair
of the tyre may not be possible. If
the tyre does not reach the correct
in
À
ation pressure within a 10-minute
period, it probably has received
more extensive damage. When this
happens, the emergency
À
at tyre
repair kit cannot be used to repair the
tyre. Contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
If the tyre has been over-in
À
ated,
loosen the screw cap on the
compressor and bleed some of the air
out.
16. When the tyre has been in
À
ated to
the proper in
À
ation pressure, turn the
compressor switch off and remove the
compressor hose from the tyre valve.
17. Install the tyre valve cap.
18. Put the emergency
À
at tyre repair kit in
the boot and continue driving.
CAUTION
Drive carefully to an expert repairer,
we recommend an Authorised Mazda
Repairer and keep the vehicle speed
below 80 km/h (50 mph).
If the vehicle is driven 80 km/h (50
mph) or higher, the vehicle might
begin to vibrate.
NOTE
(With Tyre Pressure Monitoring
System)
If the tyre is not properly in
À
ated, the
tyre pressure monitoring system warning
light will illuminate (page 4-46 ).
19. After driving the vehicle for 10 minutes
or 5 km (3 miles), check the tyre
pressure with the tyre pressure gauge
equipped with the compressor. If the
tyre pressure has fallen below the
correct tyre pressure, in
À
ate the tyre to
the correct pressure again following the
steps from number 14.
CAUTION
If the tyre in
À
ation pressure falls
below 130 kPa (1.3 kgf/cm
2
or bar,
18.9 psi), repair cannot be done with
the repair kit. Park the vehicle on
a level surface off the right-of-way
and contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
If the tyre in
À
ation pressure
continues to remain low after
repeating steps 13 to 20, park
the vehicle on a level surface off
the right-of-way and contact an
expert repairer, we recommend an
Authorised Mazda Repairer.
NOTE
When checking the tyre in
À
ation
pressure with the tyre pressure gauge
on the compressor unit, make sure the
compressor switch is turned off.
/C\FCA(-''(A'FKVKQPKPFD
/C\FCA(-''(A'FKVKQPKPFD
Содержание Mazda 6
