Mazda 2013 CX-5, Руководство по ремонту

Страница: 85 / 223

DTC U3003:08/U3003:16/U3003:17 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2902000.html[1/7/13 9:30:55 AM]
6
INSPECT DSC HU/CM GROUND FOR POOR GROUND OR
OPEN CIRCUIT
Switch the ignition to off.
Measure the resistance between the DSC
HU/CM terminal AL (vehicle harness-side)
and body ground.
Is the resistance within 0—1 ohm ?
YesGo to the next step.
No If there is open circuit:
Repair or replace
the wiring harness,
then go to the
next step.
If resistance is not within
specification:
Repair or replace
the poor ground
part, then go to
the next step.
7
VERIFY THAT THE SAME DTC IS NOT PRESENT
Reconnect all disconnected connectors.
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL (DSC)]
.)
Start the engine and drive the vehicle at 20
km/h {12 mph} or more .
Are the same DTCs present?
YesRepeat the inspection from Step 1.
No Go to the next step.
8
VERIFY THAT NO OTHER DTCS ARE PRESENT
Are any other DTCs output?
YesGo to the applicable DTC
inspection.
(See
ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY CONTROL
(DSC)]
.)
No DTC troubleshooting completed.
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.