Page 2 of 4
AS 090-M11406cma0708
2
Remove wheel well fasteners
A. Using stubby phillips screwdriver, remove plastic
fasteners and screws along front edge of both front
wheel wells that correspond to snaps on mask.
A. In both front wheel wells, using a stubby phillips
screwdriver, install wellnuts (C), washers (D) and index
snap head screws (E) into 4 holes as shown.
B. In both front wheel wells, using a stubby phillips
screwdriver, install washer (D) and #8 snap head screw
(F) into hole at fender seam.
3
Install wheel well hardware
C
D
E
F
D
Install Upper Headlight Pads
A. Lay mask (G) over front of vehicle, Starting on the drivers
side, slide upper headlight pad (H) under fender tip.
4
Install Fender Tip Pockets
A. Continue sliding upper headlight pad (H) between fender
and headlight. Install pocket (I) under fender tip.
B. Repeats steps 4 and 5 on the passengers side.
5
G
H
H
I
