Page 1 of 4
AS 090-M11406cma0708
Genuine Accessories
Installation Instructions
Part Numbers:
0000-8G-K05, 0000-8G-K03 (R3 Model)
Applicable Models:
2009 > RX8
Package Contents
Front Mask
Tools Required
Stubby Phillips
Screwdriver
Fiber Stick
(Optional)
Snap Head Screw (Qty. 2)
Front End Cover (Qty. 1)
0
Before Installation
A. Area to be covered by mask must be clean. It is recommended that you wash and wax vehicle prior to installation.
B. Both vehicle and mask must be completely dry prior to installation. If moisture under mask is allowed to dry on
vehicle, paint may cloud.
C. Any repainted surfaces in contact with mask must be allowed to cure completely. Consult paint manufacturer or
repair facility if you are not sure.
D. The use of a fiber stick may be required while inserting pads.
1
Install Hood Cover
A. With hood open, stretch hood cover (A)
onto hood, pulling each side one or two
inches at a time, until corners fit snugly.
Install hooks on ends of straps (B)
into corresponding holes on underside
of hood. Pull evenly on ends of
adjustable straps (B) until tight. Secure
loose ends in elastic loops.
A
Hood Cover (Qty. 1)
B
Washer (Qty. 10)
Wellnut (Qty. 8)
Index Screw (Qty. 8)
