Page 6 of 10
2.
After the distance verifi cation trim the
cable tie using the wire cutters and
rotate the tie wrap head up so it is
not visible from the rear of the vehicle
to avoid injury.
3. Confi rm harness is routed between the
bumper fascia and support bracket. If
so, remove all slack between tie wrap
location (a) and tie wrap location (b)
and use a large tie wrap to secure
harness to support bracket, tighten the
tie wrap and trim the tie wrap tail with
wire cutters.
4. Use a large tie wrap (c) to secure
the harness to the bottom of the
cross member of the hitch. Tie
wrap should be located 100mm
from cross member end. Remove
all slack, tighten the tie wrap and
trim the tie wrap tail with wire cutters.
3
(b)
(a)
Support
Bracket
2
(a)
TOP
5
Cross
Member
5
Cross
Member
5
Cross
Member
Cross
Member
Bottom
4
4
(c)
(c)
Continues on next page
Tie Wrap
ROTATE UP
HEAD UP
100mm
