5
2.
Rinse dispenser under warm water, then replace it.
NOTE:
Some models are equipped with a liquid fabric softener
dispenser. To avoid damage to the washer or clothing, do not
wash clothes with the liquid fabric softener dispenser removed
or add detergent or bleach to this dispenser; it is for liquid fabric
softener only.
Water Inlet Hoses
This washer does not include water inlet hoses. A list of hoses
available for purchase from Maytag is provided on the first page
of this user instructions.
Replace water inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace water inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your water inlet hoses, mark the date of
replacement on the label with a permanent marker.
Moving and Storage
Because some water may stay in the hoses, freezing can damage
your washer. If storing or moving your washer during freezing
weather, winterize it.
Winterizing your washer
1.
Shut off both water faucets. Disconnect and drain water inlet
hoses. Pour 1 qt (1 L) of R.V.-type antifreeze into the basket.
2.
Run washer on a drain and spin setting for about 30 seconds to
mix the antifreeze and remaining water.
3.
Unplug washer or disconnect power.
To use washer again
1.
Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
2.
Plug in washer or reconnect power.
3.
Run the washer through a complete cycle with 1 cup (250 mL) of
detergent to clean out antifreeze.
Storage, non-use, or vacation care
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer. This helps avoid flooding
(due to a water pressure surge) while you are away.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call
In U.S.A. www.maytag.com/help In Canada www.maytag.ca
Washer and Components
Noisy
■
Is the load balanced and the washer level?
The wash load
should be balanced and not overloaded. The washer must be
level. The front feet should be properly installed and the nuts
tightened. Reset the rear leveling legs (if needed).
See “Starting Your Washer.”
■
Did you completely remove the yellow shipping strap with
shipping pins?
See “Remove Shipping Materials.”
■
Are the gears engaging after the drain and before spin, or is the
upper part of agitator clicking during wash?
These are normal
washer noises.
Leaking
■
Check the following:
Are the fill hoses tight?
Are the fill hose washers properly seated?
■
Is the sink or drain clogged?
Sink and standpipe must be able
to handle 17 gal. (64 L) of water per minute.
■
Is water deflecting off the tub ring or the load?
Center the tub
before starting the washer. The wash load should be balanced
and not overloaded. The fill or spray rinses can deflect off the
load. The washer must be level. The front feet should be properly
installed and the nuts tightened. Reset the rear leveling legs
(if needed). See “Level the Washer.”
■
Check household plumbing for leaks.
Basket crooked
■
Was the washer basket pulled forward during loading?
Push
the basket to the center before starting wash.
■
Is the load balanced and the washer level?
The wash load
should be balanced and not overloaded. The washer must be
level. The front feet should be properly installed and the nuts
tightened. Reset the rear leveling legs (if needed). See “Level
the Washer.”
■
The washer basket moves while washing.
This is normal.
Agitator operation
■
The top of the agitator is loose, or moves in only one direction.
This is normal.
