Maytag MLE20PDAYW, Руководство по установке

Страница: 28 / 120

28
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.”
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7. Plug into a grounded outlet, or connect power.
Complete Installation
Leveling Stacked Washer/Dryer (cont.)
LEVELING
8. To test and to clean your washer, measure 1/2 the detergent
manufacturer’s recommended amount of High Efficiency (HE)
detergent for a medium-size load. Pour the detergent into the
detergent dispenser. Select any cycle and allow the washer
to complete one whole cycle.
9. Check dryer operation. Using a full heat cycle, let the dryer
run for at least five minutes. Dryer will stop when time is
used up.
NOTE: Dryer door must be closed for dryer to operate. When
door is open, dryer stops, but timer continues to run. To restart
dryer, close door and push cycle button.
If the burner does not ignite and you can feel no heat inside
the dryer, shut off dryer for five minutes. Check that all supply
valve controls are in “ON” position and that the electrical cord
is plugged in. Repeat five-minute test.
2.
Grip washer/dryer from top and rock back and forth,
making sure all four feet are firmly on floor. Repeat, rocking
washer/dryer from side to side. If washer/dryer rocks, go
to Step 3 and adjust leveling feet. If all four feet are in firm
contact with floor, go to Step 4.
to raise the washer/dryer. Recheck levelness of washer/dryer
and that all four feet are firmly in contact with the floor. Repeat
as needed.
HELPFUL TIP:
You may want to prop up front of washer/
dryer about 4" (102 mm) with a wood block or similar object
that will support weight of washer/dryer.
4. When washer/dryer is level and all four feet are firmly
in contact with the floor, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
(as viewed from above) on leveling feet tightly against
washer/dryer cabinet.
HELPFUL TIP: You may want to prop washer/dryer with
wooden block.
3. If washer/dryer is not level, use a 9/16" or 14 mm openend
or adjustable wrench to turn jam nuts clockwise (as viewed
from above) on feet until they are about 1/2" (13 mm)
from the washer/dryer cabinet. Then turn the leveling foot
counterclockwise to lower
the washer/dryer or clockwise
Jam nut