28
4.
Close the door.
5.
Press the POWER button.
6.
Select a timed drying cycle and temperature (see following chart). Items containing foam,
rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
7.
You must select a time by pressing TIMED CYCLE ADJUST Up or Down. Reset time as
needed to complete drying. Refer to the following table.
8.
Press (and hold) START button (about 1 second).
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting and drying time. Actual drying time will depend on the amount of
moisture items hold.
*(Minutes) Reset time to complete drying, if needed.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
Cleaning the Lint Screen
Clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■
Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
■
If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every load cleaning
1.
The lint screen is located on the top of the dryer. Pull the lint screen toward you. Roll lint
off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
2.
Push the lint screen firmly back into place.
Rack Dry
Setting
Temp.
Time*
Wool Sweaters
Block to shape and lay flat on the drying
rack.
Timed Dry
Low
60
Stuffed toys or pillows
Cotton or polyester fiber filled
Timed Dry
Low
60
Stuffed toys or pillows
Foam rubber filled
Timed Dry
Air Fluff (no
heat)
90
Sneakers or canvas shoes
Timed Dry
Air Fluff (no
heat)
90
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
