5
WIRED MAGNET AND POWERED DOOR
SENSOR OPTION
In cases where there is no top door frame, the sensor will
need to be mounted on the wall next to the door. In these
cases a wired magnet (a field supplied single pole single
throw wired magnet) can be recessed or surface mounted
and wired to the door sensor. The magnet will be a recessed
style magnet with wired switch. The wires for the sensor
(20 gauge field supplied) in the magnet will need to be run
during construction. Two wires will be run from the door
sensor location to the PTAC unit; the remaining two wires
will be run from the magnet location to the sensor location.
The door sensor has four (4) terminal locations for wired
power and/or wired magnets. The two (2) terminals closest
to the binding button are for wired magnet and the top two
(2) terminals are for wired power.
Run the magnet wires through the opening in the center of
the door sensor wall plate.
CONNECTING MAGNET
Using a pocket size straight blade screw driver push down
on the terminal button to open the socket, insert wire into
socket and release the terminal button. Insert one wire into
each of the two (2) terminals. See following image for wire
locations.
POWER CONNECTION
If using the wired powered option for the door sensor, using
a pocket size straight blade screw driver, push down on the
terminal button to open the socket. Insert wire into socket
and release the terminal button. Insert one wire into each
of the two (2) terminals. See following for wire locations.
Connect the power wires from the door sensor to the PTAC
on terminals C & R. The wire harness kit PWHK01C is
required for this connection.
+
-
+
-
Binding Button
Wired
Magnet
Connection
Power Connection
Battery Holder
Viewed from the back with the power block
in upper right corner.
Pins
+
-
Binding Button
Wired
Magnet
Connection
Power Connection
Battery
Holder
Jumper
on Pins
Battery
Connection
Note: For battery connection, the jumper must be placed as
shown above
+
-
Binding Button
Wired
Magnet
Connection
Power Connection
Battery
Holder
Jumper
on Pins
Powered
Connection
Note: For 24v powered connection, the jumper must be
placed as shown above
