WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
26
16022506 Rev. 0
©2003 Maytag Appliances Company
CAUTION
!
To avoid risk of personal injury or property damage this
unit requires a two person lift when lifting unit in or out
of cutout.
Removing and Replacing Unit
1. Turn off power to the oven at the circuit breaker.
2. Open oven door and remove screws securing unit to
the cabinet opening.
NOTE: Place a protective covering on the floor, to avoid
damage to the floor.
3. Pull unit forward out of the cabinet opening.
4. Disconnect or unplug the power cord leading from unit
to fuse box or junction box depending on unit.
5. Replace the oven using the installation instructions.
Control Panel Assembly
1. Turn off power to unit.
2. Remove screws securing trim piece(s) to the cabinet.
3. Slide unit out of cutout approximately 6 to 8 inches.
CAUTION
!
To avoid risk of property damage and personal injury,
place blocking material undernieth the front edge of the
wall oven to prevent unit from tipping forward.
4. Remove screws securing control panel assembly to
unit chassis.
5. Label and disconnect wire terminal plugs from control
board assembly.
CAUTION
!
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
6. Place control panel assembly on a protected surface.
7. Reverse procedure to reassemble.
Control Board Assembly
1. Remove control panel, see “Control Panel Assembly”
procedure, steps 1 through 6.
2. Remove screws securing control board bracket to
control panel assembly.
3. Label and disconnect ribbon terminal plug from control
board assembly.
4. Replace control board assembly and reverse
procedures to reassemble.
Touch Panel
1. Remove control panel, see “Control Panel Assembly”
procedure, steps 1 through 3.
2. Remove screws securing touch panel to control panel
assembly.
NOTE: Touch panel is loose, but the ribbon cable does
not allow complete removal.
3. Disconnect ribbon cable from touch panel and remove
touch panel.
CAUTION
!
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
4. Replace touch panel and reverse procedure to
reassemble.
Side Trim(s)
1. Remove control panel, see “Control Panel Assembly”
procedure, steps 1 through 3.
2. Remove screws securing trim piece to unit chassis.
3. Replace side trim and reverse procedure to
reassemble.
Stepdown Transformer(s)
NOTE: Requires removal of unit from cabinet.
1. Turn off power to unit.
2. Remove screws securing trim piece(s) to the cabinet.
3. Remove unit from cutout.
4. Remove screws securing top cover to outer shell and
remove top cover.
5. Label and disconnect wire terminals from transformer.
6. Remove screws securing transformer to control box.
7. Replace transformer and reverse procedure to
reassemble.
