16
Maintenance
Checking the fastenings
Check the tightness of nuts and bolts at least once a month and re-tighten if necessary.
Lubricating the sliding tubes
The top of the sliding tubes must be cleaned and lubricated regularly. Clean the sliding tubes with a damp cloth
and some liquid hand soap or detergent. For professional cleaning we recommend the MAXXUS® Degreaser
Spray. Then dry the sliding tubes thoroughly and lubricate the top of the tubes with liquid silicone or MAXXUS®
lubricant spray to form a thin layer.
With frequent use, you should clean and lubricate the sliding tubes once a week. Lubricate the sliding tubes im-
mediately if squeaking sounds occur during training. Care and cleaning agents are available in our online shop
at www.maxxus.com or in our showroom in Weiterstadt.
Lubricating the axles on the handlebar stem and on the drive discs
The two transverse axles on the handlebar stem, and the axles on the large drive discs, should be lubricated
once every 6 months with multipurpose grease - please refer to the appropriate section in this manual.
Mains Cable
Plug the mains cable on the supplied mains adapter into the socket located on
the front of the main body. Then plug the mains cable into a power socket.
CAUTION
The device may only be connected to an earthed socket that has been professionally installed. Do not use mul-
tiple sockets to connect the exerciser. If you use an extension cable, it must comply with the guidelines of the
VDE or equivalent.
Connecting the device
CAUTION:
Before connecting mains adapter to the unit, always check that it is the adapter delivered with the unit. Using a
different mains adapter may cause damage to the electronic components of the device, for which the manufac
-
turer cannot assume liability.
Always connect the mains cable to the training device before connecting it to a power outlet. If you want to dis-
connect your exerciser from the power supply, always disconnect the power cable from the mains first.
Switching on the device
First connect the power cable to the training device and then to the power outlet. The cockpit will turn on au-
tomatically. If the training device is already connected to the power supply but the cockpit is in stand-by mode,
activate the cockpit by pressing any key or by moving the pedals.
Switching off the device
After 4 minutes of inactivity the cockpit automatically switches into stand-by mode. Always disconnect the train-
ing device from the mains once you have finished your workout. Unplug the power cable from the wall socket
first and then remove the mains adapter from the device.
Maintenance & Care
Mains Connection
