D08
A01
D09
43
ENG
CAUTION.
Before you begin cleaning, maintenance and / or repair work, the training device must be completely discon
-
nected from the mains power. Disconnect the power plug from the wall outlet and then disconnect the power
cord from the exerciser. The power cord may only be reconnected to the exerciser and the mains when all work
has been fully completed and the device has been restored to its proper training position.
Cleaning
Clean your exerciser after each workout. Use a damp cloth and soap, do not use solvents. Regular cleaning
contributes significantly to the maintenance and longevity of your training device. Due to the chemical compo
-
sition of body sweat this is the main cause of corrosion (rust) if it is not immediately removed / cleaned. After
every training session, check whether body sweat and / or other liquids have come into contact with the device.
If this is the case clean the affected components / covers.
Please note:
Damage caused by body perspiration or other liquids is
not covered by the warranty under any
circumstances.
Make sure that no fluid can penetrate the exerciser or the computer while exercising.
Maintenance
Checking the fastenings
Check the tightness of nuts and bolts at least once a month and re-tighten if necessary.
Power Cable
Plug the connection cable of the AC power adapter supplied into the socket on the back of the main housing
then connect the power connector of the AC adapter to a wall mains socket.
CAUTION:
The device may only be connected to a socket that has been professionally installed and earthed. Do not con-
nect the training device to multiple sockets. If you use an extension cable, you must ensure that this complies
with the guidelines of the VDE.
The socket for the AC adapter is located at the rear end of the main body above the rear stand.
Connecting the device
CAUTION:
Before connecting the mains adapter to the device, always check that it is the same as the one supplied with the
device.
Using another AC adapter may damage the electronic components of the device for which the manufacturer can
accept no liability.
Always connect the power cable to the training device before connecting it to a power outlet. If you disconnect
your training device from the power supply, always disconnect the power cable from the power outlet first.
Switching on the Device
First connect the power cable to the training device and then to the power outlet, the cockpit turns on auto-
matically. If the training device is already connected to the power supply and the cockpit is in stand-by mode,
activate the cockpit by pressing any key or by moving the pedals.
Switching off the Device
After more than 4 minutes inactivity, the cockpit automatically switches to stand-by mode.
As soon as you have finished your training you should disconnect the training device from the mains. Always
remove the plug from the power socket first and then remove the plug from the training device.
Care and Cleaning
Mains Connection
