Maxum 4100 SCA Sportyacht, Дополнение к руководству пользователя

Страница: 18 / 56

12 Chapter 2: Components/Systems
4100 SCA Sport Yacht
•
Owner’s Manual Supplement
Shore Power
30 Amp Shore Power
Your yacht features two standard-equipped 120v/30 amp shore power
receptacles (located inside the starboard transom stowage tub). The
receptacles inlet, labeled line 1 and line 2, correspond to the master
breakers, labeled line 1 and line 2 on the AC panel. This system is
designed so that each line operates independent of each other.
50 Amp Shore Power (Option)
A single 50 amp receptacle inlet may be installed in place of the two
standard 30 amp receptacle inlets. Electricity from the single 50 amp
inlet (240 volt) is evenly distributed to both line 1 and line 2 master
breakers (120 volt) on the AC panel. This system is designed so that
each line operates independent of each other.
Connecting To Shore Power
1. Monitor the AC panel’s polarity indicator lights (next to the line 1 and line 2 master breakers) as follows:
•
A green light illuminating after the power cord is plugged into the yacht’s external power receptacle indi-
cates acceptable electrical power in which you may energize the main breaker switches.
•
A red light, however, indicates reversed polarity, which could cause electrical system damage and possibly
electrical shock injuries. In this case, do not energize the main breaker switches (see warning below).
2. Activate the AC system by turning the main ship/shore breaker(s) to the dockside position.
3. Turn on the master breaker and individual component breakers (below the activated master breaker) as required.
30 AMP SHORE POWER INLETS
AND BREAKER
MAIN
BREAKERS
30 AMP SHORE
POWER INLETS
50 AMP SHORE
POWER INLET
MAIN
BREAKER
TV/TELEPHONE
INLET (OPTION)
(OPTIONAL) 50 AMP SHORE POWER INLET
AND BREAKER
NOTI CE
•
Some dockside installations may be rated less than 30
amps, therefore, you may need to purchase lower amp
adapters.
•
Adapters should always be used at the dockside end of a
shore power cord.
•
Whenever a lower amp adapter is used, however, there will
be a corresponding drop in supplied power from the dock-
side system.
Voltage on each line can be read by setting the voltmeter selector switch.
NOTI C E
SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
•
Monitor the polarity indicator lights every time you connect to shore power.
•
When connecting to shore power and you encounter reversed polarity light (red colored),
Do not energize the main breaker switches. Instead, immediately disconnect the shore power
cord (always from the dockside receptacle first) and notify marina management.
WARN I NG!
!