10
3.4 Enroll and Program Handheld Keypads (WLS910)
For the handheld keypads to work on the system, you need to enroll them. You
may also want to program the function keys. You can enroll up to four handheld
keypads on the PC4164-RS.
Step 1: Enroll Handheld Keypads
1. At a system LCD keypad, enter [*][8][Installer’s code].
2. Enter Ref #[001300] to go to the Enroll Device programming section.
This section will only be available if you have enrolled the PC4164-RS with the
panel (see Section 2.6). The LCD keypad will display
Enroll Device Serial # [ ]
.
3. Look at the back of the handheld keypad. If it has a 6-digit serial number, enter
it now. If it only has a 5-digit number, enter a [0] and then the 5-digit number.
4. The display will show Select (01) Partition 1. Scroll to the partition the keypad
will be enrolled on. Press [*] to select the partition for the keypad.
NOTE
: Handheld keypads will not work when the partition they are assigned to are
being accessed for zone bypassing or programming
5. The display will show Enroll Device HHK #XX, where XX = the slot the WLS910
is assigned to (1 to 4).
Record the serial number and assigned slot number in the programming
worksheets in the back of this manual.
6. Repeat steps 3 – 5 until all handheld keypads have been enrolled.
7. To exit, press [#].
NOTE:
To change the partition a handheld keypad is assigned to, you must delete and
then re-enroll the keypad.
I N S T A L L I N G W I R E L E S S D E V I C E S
