MaxPro MPBBG200, Руководство пользователя, Страница: 7 / 70

B Bench Grinder MPBBG200 User Manual
7
Tighten the adjusting screw.
Instructions for use
Before switching on the machine, check if all screws and nuts are tight and if the grinding wheel can rotate
freely.
Always grind on the front part on the grinding wheel. Never overcharge the machine, causing the grinding
wheel to come to a halt.
The machine is not intended for permanent use. Make sure that the machine is not overheated.
After using the machine for 30 minutes, let it cool down to ambient temperature.
Switching on and off (fig. A)
To switch the machine on, set on/off switch (1) to ‘1’
To switch the machine off, set on/off switch (1) to ‘0’
CLEANING AND MAINTENENCE
Always pull out the mains power plug before starting any cleaning work.
Cleaning
ͻ<ĞĞƉĂůůƐĂĨĞƚLJĚĞǀŝĐĞƐ͕ĂŝƌǀĞŶƚƐĂŶĚƚŚĞŵŽƚŽƌ housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
ͻtĞƌĞĐŽŵŵĞŶĚƚŚĂƚLJŽƵĐůĞĂŶƚŚĞĚĞǀŝĐĞ immediately each time you have finished using it.
ͻůĞĂŶƚŚĞĞƋƵŝƉŵĞŶƚƌĞŐƵůĂƌůLJǁŝƚŚĂŵŽŝƐƚ cloth and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the
device.
Carbon brushes
In case of excessive sparking, have the carbon brushes checked only by a qualified electrician.
Important! The carbon brushes should not be replaced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which require additional maintenance.
ENVIRONMENT
ͻ Do not dispose of electric tools, accessories and packaging together with household waste material
- in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility
TROUBLE SHOOTING
Fault Symptom Possible Cause Troubleshooting
Electric motor out of
service
Disconnection between plug and
power socket
Put plug in power socket
Shortcircuit in power supply Repair and reconnection
At switch-off Switch on
Loose switching contact Replace switchboard by repairer
Capacitor damage Replace capacitor by repairer
Burnout of stator coil Replace stator by repairer
Stator wiring disconnection Reconnection by repairer
Wiring disconnection Check electric circuit connection by repairer
2
Sluggish start-up, falling
short of running speed
Unsmooth running in mechanical
part
Check mechanical part by repairer
Burnout of switch contact Replace switchboard by repairer
Capacitor damage Replace capacitor by repairer
Low supply voltage Regulate supply voltage
3 Excessive running noise Electric motor at fault Check motor by repairer
1
GB