MaxPro 111-0302, Руководство пользователя

Страница: 7 / 79

IImpact Drill MPID1050VD User Manual
7
Inserting the Drill
First remove the mains supply from the socket. Turn the ring of the drill chuck (1) until the clamping jaws
are open wide enough. Insert the drill into the clamping jaws of the drill chuck (1). Insert the end of the
drill chuck key (7) into one of the three holes on the body of the drill chuck (1) and let the head of the key
(7) lock into place in the ring of the drill chuck (1). In order to tighten the clamping jaws and fix the drill in
place, turn the drill chuck key (7) in a clockwise direction. Important: Then remove the key (7) from the
chuck (1)!
Working with the Drilling Machine
Ensure that the mains power supply voltage is the same as the operating voltage of your machine. For
details, please see the type plate. Insert the correct drill for the type of job to be performed. If necessary,
adjust the bit stop. Set the High/low speed selector (8) to the desired speed position, then adjust the
speed of the machine using the regulating wheel on the operating switch (6). The more the operating
switch (6) is pressed in, the faster the drill rotates. Set the direction switch (4) to the desired direction of
motion. Never alter the position of the percussion drilling switch (3) or the direction switch (4) when the
machine is switched on. The machine is switched on by pressing the operating switch (6). When the
operating switch (6) is released, the machine stops. If you would like to use continuous operation press
the locking button (5) while the operating switch (6) is pressed. In order to switch off the machine during
continuous operation, press the operating switch (6) again and then let it go. Do not touch the drill chuck
(1) while the machine is switched on.
Drilling Tips
1. Always insert the correct size and type of drill or screwdriver.
2. Set the machine to the correct speed.
3. Always hold the machine tightly by the handle and second handle (2).
4. When drilling wood and metal, set the percussion-drilling switch (3) to drilling.
5. When drilling masonry, set the percussion-drilling switch (3) to percussion drilling.
6. When using the machine as a screwdriver, set the percussion-drilling switch (3) to drilling.
7.
Set the direction switch (4) to the correct direction.
8.
Never change the direction of motion when the machine is switched on.
Overload
Never use excessive force when drilling. Too much pressure reduces the speed of the machine, and the
required power is greatly reduced. This may result in overload, which can damage the motor of the
drilling machine. When the drilling machine becomes too hot, allow it to run for two minutes without a
load and then interrupt working for a short time. Clean the drilling machine with a clean cloth and a
brush. Ensure that the ventilation slits are not blocked.
3
GB