11921
Slauson
Ave.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
F
AX
(888)
771-7713
PAGE 4
INTRODUCTION
This publication contains the information required to install the
80-3LM, 80-4LM
. If
there is any doubt regarding the suitability of these lifts being installed on its intended
vehicle, or any portion of these instructions that you do not understand, please contact the
MAXON Customer Service Department
for consultation.
Unauthorized modification to this equipment may cause premature failure or create
hazards in its use that are not foreseen at the time of installation. These kinds of changes
should be discussed with our Engineering Department before being undertaken.
Before you start!
The dimension of the open liftgate Platform length must be added to the
body length when considering proper weight distribution on the truck chassis.
In other words, be mindful of the possibility that a loaded liftgate could raise
the front wheels off of the ground.
1.
When installing Taillight Systems, consult the Chassis or Trailer
manufacturers instructions for splicing into the vehicles lighting circuit.
2.
CONSPICUITY DECALS:
Federal Motor Vehicle Safety Standards call
out for the placement of retro-reflective sheeting, or reflex reflectors on all
vehicles prior to their being delivered. These decals or reflectors are not
supplied with the lift gate. Refer to the standard for details.
CAUTION!
When all else fails, read the
instructions.
