Maxon GPT Series, Руководство по установке

Страница: 28 / 38

1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
28
STEP 14 - WELD DOCK BUMPERS TO LIFTGATE
1. Lower the Platform to the ground (Operation Manual M-97-16) .
2. Clamp a Dock Bumper to Left Hand (LH) side of Extension Plate as shown in FIG. 28-1A .
Weld the Dock Bumper to Extension plate as shown in FIG. 28-1B . Make sure bolt holes in
the Dock Bumper are visible from the rear of the vehicle. Repeat step for Dock Bumper on
Right Hand (RH) side of Extension Plate.
3. Clamp open end of Brace to Dock Bumper as shown in FIG. 28-1A.
Clamp closed end of Brace to Main Frame (FIG. 28-1A) . Weld the
Brace to Dock Bumper (FIG. 28-1A) and Main Frame (FIG. 28-1C) .
Repeat step for Brace and Dock Bumper on RH side of Extension Plate.
4. Raise and lower Platform then stow Liftgate (Operation Manual M-97-16) . Make sure
Dock Bumper does not interfere with Liftgate.
DOCK BUMPER
BRACE
2 PLACES
LH & RH BRACES
3/16”
MAIN FRAME
GRIND OFF
SHARP
CORNERS
EXTENSION
PLATE
3/16”
2 PLACES
LH & RH DOCK
BUMPER
WELDING ANGLE TO EXTENSION PLATE
FIG. 28-1B
TYPICAL DOCK BUMPER & BRACE
POSITIONING (LH SIDE SHOWN)
FIG. 28-1A
FLAT
(PART OF BRACE)
LINE UP BOTTOM EDGES AT
THIS POINT.
BRACE
(CENTERED
BETWEEN 2 PINS)
FIG. 28-1C
PINS