Maxon BMR-CS, Руководство по установке

Страница: 102 / 103

102
1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
Operation Inspection:
All BMR-CS
 Liftgate operates correctly using all main &
optional control switches.
 Platform unfolds in 5 to 7 sec.

Platform can be lowered onto the bottom stop
position for dock loading, and 1” below the
threshhold plate.
 Platform folds in 5 to 7 sec.

Unloaded platform lowers in
8 to 20 sec
.
 Unloaded platform raises in
9 to 21 sec
.

Unloaded platform raises and lowers evenly in
GD and PD modes. Maximum 1” difference of
runners from side to side.
 Platform stores securely behind both column
wedges.
 Cycle counter indicates total number of up and
down cycles and adds 1 more count each time
platform is raised and lowered.

Decals in correct location and legible.
Verify all lights are operational
 Platform lights turn
ON
when platform is un-
folded, and turn
OFF
when platform is stowed.
 Taillights, stop lights, turn lights, and backup
lights turn
ON
and
OFF
correctly.
Pre-Installation Inspection:
 Correct model  Correct capacity
 Correct platform size  Correct options
 Correct manuals & decals
Structural Inspection:
 Liftgate is centered on vehicle rear door &
mounted per dimensions in this manual.
 Pump box is mounted securely.
 All installation welds are done per instructions
in this manual.
 All roll pins, bolts & fasteners on liftgate
are tight.
 All hardware & fasteners, used to secure
liftgate to vehicle body, are tight.
 Ensure platform ramp touches ground when
runner is 1” above ground. The main platform
&
fl ipover surfaces should be level to one
another and rest evenly when touching the
ground.
 Verify runner slide pads are in adjustment per
STEP 18
in this manual.
Hydraulic Inspection:
 Fluid is at correct level (See
OPTIMIZE HY-
DRAULIC FLUID LEVEL
step in this manual.)
 No leaks from hydraulic fi ttings in pump box
 No leaks from hydraulic line connections
Electrical Inspection:
 Power/charge plug and terminals are clean &
tight.
 Individual wire connections are tight.
 Circuit breaker (150A) is installed in battery box
(if equipped) or by truck/tractor battery.
 Batteries are fully charged, all cable
connections are tight & tiedowns are tight.
 Solenoid wiring connections are tight.
 Wiring harness connections are tight.
 Electrical cable connections are tight &
secured clear of moving parts & sharp edges.
Model:______________________ Date: ____________________
Serial Number: _______________ Technician: _______________
PRE-DELIVERY INSPECTION FORM
Important!
This pre-delivery checklist is to aid the installer in con fi rming the proper installation of
this Maxon product. It is not a comprehensive list and does not replace the use of the installation
manual. The installer is responsible for following all instructions in the installation manual.
NOTE: The following times are for 56” bed
height, aluminum platform and
fl ipover, 85” W x 42” + 42” L, Exxon
Univis HVI-13 oil, & temperature at
70°F. Times are for reference only
and may vary for larger platforms,
smaller platforms, steel platforms, or
temperature changes.