Accessories
Extension Modules
maxon motor control
EPOS2 Positioning Controller
Document ID: rel8458
4-33
EPOS2 Module 36/2 MoBo Hardware Reference
Edition: November 2018
© 2018 maxon motor. Subject to change without prior notice.
A
UXILIARY
P
ORT
C
ONNECTOR
(J2)
Used to mate with the motherboard’s Auxiliary Bay Connector (J6).
Figure 4-36
Auxiliary Port Connector (J2)
Maximal permitted electrical Load
• Max. current (track handling): 1.0 A.
• Max. current (supplied by EPOS2 Module 36/2):
Note
*1) Voltage level “low” = 0 V, “high” = 3.3 V, connected directly to the DSP
*2) EIA RS232 Standard
*3)Total ampacity on voltage 5 VDC is 150 mA and divides as follows:
• Encoder supply v5 VDC/100 mA
• Hall sensor supply v5 VDC/30 mA
• Auxiliary output v5 VDC/20 mA
P
OWER
LED (P
WR
)
Illuminated by motherboard’s +5 VDC rail.
Figure 4-37
Power LED (Pwr)
Pin
Array / Signal
Description
1
B13 DigIN1
Digital Input 1
2
A19 AnIN1
Analog Input 1
3
B19 DigIN7\
Digital Input 7 “High Speed Command” complement
4
B18 DigIN7
Digital Input 7 “High Speed Command”
5
A20 AnIN2
Analog Input 2
6
V
cc
Power supply voltage
7
GND
Ground
8
GND
Ground
9
10
+5 VDC/20 A
Auxiliary output v5 VDC
*3)
11
B20 DigIN8
Digital Input 8 “High Speed Command”
12
B21 DigIN8\
Digital Input 8 “High Speed Command” complement
13
A28 EPOS TxD
EPOS RS232 transmit
*2)
14
A26 EPOS SCI TxD
Serial communication interface transmit
*1)
15
A27 EPOS RxD
EPOS RS232 receive
*2)
16
A24 EPOS SCI RTS
Serial communication interface handshake
*1)
17
A25 EPOS SCI RxD
Serial communication interface receive
*1)
18
B14 DigIN2
Digital Input 2
19
B23 DigOUT2
Digital Output 2
20
A22 DigOUT5
Digital Output 5
