BEVEL SCALE AND BEVEL INDICATOR
The bevel scale and bevel indicator show the angle of the saw blade with respect to the
work table.
STORAGE COMPARTMENT
Located under the right side of the work table used for storage of small accessories such
as saw blades or hex keys.
BLADE GUARD
Protects the operator’s hand from being cut while providing a clear view of the material
to be cut during cuts.
BLADE TENSION KNOB
Loosen or tighten blade tension by pushing the blade tension lock knob up or down.
DROP FOOT AND DROP FOOT LOCK KNOB
The drop foot should be lowered until it just rests on top of the workpiece to prevent the
workpiece from lifting, yet not so much that the workpiece drags. The vertical portion
provides a blade protector to prevent accidental blade contact.
VARIABLE SPEED KNOB
Turn the knob to adjust the speed from the high speed of approximately 1600 RPM to the
low speed of approximately 400 RPM.
DUST BLOWER
The dust blower keeps the line of cut on the workpiece clean for more accurate scroll
cuts. For best results, always direct air flow at the blade and the workpiece.
LED LIGHT
With an easy On/Off switch, the LED light keeps the line of cut on the workpiece lit for
more accurate scrollcuts.
DUST EXTRACTION PORT
This feature will alow you to attach the vacuum hose for easy dust collection.
LED LIGHT SWITCH
A power switch that turns the LED light on and off.
BEVEL ADJUSTMENT KNOB
Allows you to tilt the table and lock it at the desired angle, up to 45° right and left.
UPPER AND LOWER BLADE HOLDERS
Upper and lower blade holders provide support and location of the saw blade.
TABLE INSERT
The table insert is located on the table slot to support the workpiece with respect to the
blade. It prevents movement of the workpiece from the work table.
WORK TABLE
The surface where the workpiece is attached to while performing cutting operations.
15
KNOW YOUR SCROLL SAW
14
KNOW YOUR SCROLL SAW
RUBBER FEET
The rubber feet are provided on four corners of the table base.
TO AVOID INJURY FROM KICKBACK:
•
Hold the workpiece firmly against the tabletop.
•
Do not feed the workpiece too fast while cutting. Only feed the workpiece at the rate
the saw will cut.
•
Install the blade with the teeth pointing downward.
•
Do not start the saw with the workpiece pressing against the blade. Slowly feed the
workpiece into the moving blade.
•
Use caution when cutting round or irregularly shaped work pieces. Round items will
roll and irregularly shaped work pieces can pinch the blade.
model no. 055-6706-6 | contact us 1-800-689-9928
model no. 055-6706-6 | contact us 1-888-670-6682
Содержание 055-6706-6
Страница 1: ......
