1
WARNING!
To prevent accidental starting that could cause possible serious
personal injury, turn off the saw and unplug the saw from the
power source before making any adjustments.
NOTE:
All bolts should be inserted from the top. Install the washers
and nuts from the underside of the bench.
Fig. 3
Fig. 4
Fig. 5
•
Place scroll saw on workbench. Using the saw base as a pattern, locate and mark the
holes where the scroll saw is to be mounted.
•
Drill four holes through the workbench.
•
Place scroll saw on workbench, aligning holes in the saw base with the holes drilled
in the workbench.
•
Insert all four bolts and tighten securely with washers and nuts.
Supporting surface where scroll saw is mounted should be examined carefully after
mounting to insure that no movement during use can result. If any tipping or walking is
noted, secure workbench or supporting surface before beginning cutting operations.
Reducing Noise and Vibration:
You may wish to place a foam pad or piece of carpet between the saw base and the
workbench to help reduce noise and vibration.
If a foam pad or piece of carpet is used, do not overtighten the mounting bolts. Leave
some cushion between the padding and the saw base to help absorb the noise and
vibration.
The thickness of the padding material should be approximately 1/2" (13 mm).
19
ASSEMBLY
18
ASSEMBLY
DUST BLOWER ADJUSTEMT (Fig. 4)
The attached dust blower (1) is designed to direct
air to the cutting line. Adjust the dust blower to
the desired position. For the best results, always
direct air flow at the blade and the workpiece.
LED LIGHT ADJUSTEMT (Fig. 5)
Input voltage : 3.2-3.4 V
Input current: < 55 mA
With an easy On/Off switch (1), the attached LED
light (2) keeps the cutting line on the workpiece
lighted for more accurate scroll cut. Adjust the
LED light to the desired position.
• To turn On the LED light, press the “I” button.
• To turn Off the LED light, press the “O” button.
Fig. 6
SQUARING THE SAW TABLE TO THE BLADE (Fig. 6-8)
• Open the blade guard (1) upward.
• Loosen the screw (2) and remove the drop
foot (3).
• Loosen the bevel adjustment knob (4) to tilt the
work table until it is approximately perpendicular
or at right angle to the blade.
2
1
DROP FOOT ADJUSTMENT (Fig. 3)
To prevent workpiece from lifting, the drop foot (1)
should be adjusted so it just rests on the top of the
workpiece. The drop foot should not be adjusted so
that the workpiece drags.
Always retighten the drop foot lock knob (2) after
each adjustment has been made.
•
Loosen the drop foot lock knob (2).
•
Lower or raise the drop foot (1) to the desired
position.
•
Retighten the drop foot lock knob (2).
The tall, front part of the drop foot acts as a blade protector to prevent accidental
contact with the blade.
2
1
1
3
2
model no. 055-6706-6 | contact us 1-800-689-9928
model no. 055-6706-6 | contact us 1-888-670-6682
Содержание 055-6706-6
Страница 1: ......
