Maximum 054-8382-4, Инструкция по эксплуатации

Страница: 18 / 31

18
model no. 054-8382-4 | contact us 1-888-670-6682
TO ADJUST BEVEL SETTING (fig 8)
The saw is equipped with a 45° stop to
quickly set for 45° bevels. To set 45-56°
bevel, raise the stop.
1. Unplug the circular saw from the power
supply.
2. Loosen the bevel-adjustment
locking knob by rotating the knob
counterclockwise.
3. Tilt the base until the bevel indicator reaches the desired setting on the bevel
scale.
4. Tighten the bevel-adjustment locking knob by rotating the knob clockwise.
0° BEVEL STOP
The saw has a 0° bevel stop that has been adjusted before shipment to assure
that the blade is vertical to the base at the 0° bevel setting.
TO CHECK 0° BEVEL STOP (fig 9)
1. Unplug the circular saw from the power
supply.
2. Using a carpenter’s square (available
separately), check the squareness of
the saw blade to the base of the saw.
TO ADJUST 0° BEVEL STOP (fig 10)
1 . Unplug the circular saw from the power
supply.
2. Loosen the bevel adjustment knob.
3. Use a hex wrench (5mm, available
separately ) to turn the 0° stop
adjusting screw until the base is square
with the saw blade.
fig 8
45° stop
fig 9
Blade
Base
Carpenter’s
square
fig 10
Adjusting
screw
WARNING!
• Attempting a bevel cut without fully tightening the bevel adjusting locking
knob can result in serious injury.
FPO
A
S
SEMBL
Y INS
TRUCTIONS