Maximum 054-8382-4, Инструкция по эксплуатации

Страница: 14 / 31

14
model no. 054-8382-4 | contact us 1-888-670-6682
BLADE GUARD SYSTEM (fig 2)
The lower blade guard attached to your
circular saw is there for your protection
and safety. It should never be altered for
any reason. If it becomes damaged or
begins to return slowly or sluggishly, do
not operate the saw until the blade guard
has been repaired or replaced. Always
leave the guard in its correct operating
position when using the saw.
SAW BLADES
All saw blades need to be kept clean, sharp and properly set in order to cut
efficiently. Using a dull blade places a heavy load on the saw and increases the
danger of kickback. Keep extra blades on hand, so sharp blades are always
available. Gum and wood pitch hardened on the blade slows the saw down. Use
gum and pitch remover, hot water or kerosene to remove them. Do not use gasoline.
KICKBACK
Kickback occurs when the blade stalls
rapidly and the saw is driven back
towards you. Blade stalling is caused by
any action that pinches the blade in the
wood (fig 3).
IMPORT
ANT INFORMA
TION
fig 3
Kickback-Blade set too deep
fig 2
Lower blade guard is in
the up position when
making a cut