19
TIGHTENING THE WHEEL
GUARD
(fig 9)
1. Disconnect the plug from the electrical
outlet.
2. Remove the flanges and the wheel;
refer to the section “
INSTALLING AND
REMOVING THE GRINDING WHEEL
”.
3. Open the guard latch and rotate the
guard to a proper position.
4. Close the guard latch and tighten the screw on the guard with a screw driver
(not supplied).
NOTICE:
After the wheel guard tightened, the guard should be fixed firmly
when the latch is closed and rotated normally when the latch is opened.
WARNING!
• You should not be able to rotate the wheel guard by hand when
the guard latch is closed. Do not operate the grinder with a loose
guard or the guard latch in the open position.
• When servicing, use only identical replacement parts. The use
of any other parts may create a hazard or cause damage to
the product. For more information, call the toll-free helpline, at
1-888-670-6682.
• Use only accessories that are recommended by the manufacturer
for your model. Accessories that may be suitable for one tool
may become hazardous when used with another tool.
• Maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools, with sharp cutting edges, are less
likely to bind and are easier to control.
• If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the service organization.
FPO
MAINTENANCE
fig 9
Screw
