Maximum Controls MAX MEGATRON 2500, Инструкция по установке и эксплуатации

Страница: 27 / 44

2 5
matrix 1
Turned OFF - Close timer will close the gate. If an in-ground safety or exit loop
gets activated during the close cycle, gate will REVERSE to the open position.
Turned ON - (In-ground loops required) Gate will close after all the in-ground
loops have been cleared no matter how long the close timer is set for. If an
in-ground safety loop gets activated during the close cycle, gate will REVERSE
to the open position.
Turned ON - (In-ground loops required) Gate will close after all the in-ground
loops have been cleared no matter how long the close timer is set for. When an
in-ground safety loop gets activated during the close cycle, gate will
PAUSE and
NOT reopen. When loop is cleared, gate will continue to close preventing
UNAUTHORIZED entry.
anti tailgate
Single pass anti-tailgate
24V GND
UL ALARM 12V
ALARM RET
RESET
GND
GATE
TAMPER
MAG
LOCK
OPEN
RIGHT
OPEN
LEFT
MAGLOCK
DELAY
PRIMARY
GATE
SAFETY CENTER EXIT
OPEN
MAX
GATE SPEED
STOP CLOSE
ANTI
TAILGATE
CLOSE TIMER
POSITION
RECORDER
ID
PLUG
AUTOMATIC OPEN/CLOSE CONTROLS
BATTERY
BACK-UP MODE
MATRIX 1
PHOTOCELL
EDGE 1
EDGE 2
ID PLUG
ERROR
OPEN
COM
CLOSE
Tamper NO
COM
GND
Tamper IN
OFF
OFF ON
EXIT
PARTIAL
OPEN
OBD PORT
BLACK BOX
MOTOR MOTION
CENTER
REVERSE SENSITIVITY
MOTOR OVERLOAD
NO LIMIT SWITCH /
CLAMP SLIPPING
MIN
MAX
12VDC
GND
24VDC
GND
MAX
MIN
OFF
SAFETY
LEAVE
OPEN
LEAVE
CLOSED
MADE in USA OPEN
1 TIME
2Sec 1.5Sec
COM
NC
BATTERY
IN USE
POWER
GATE
STATUS
(+) GND (-)
PRIMARY
GATE
(+) GND (-)
SEC
GATE
UL
ENTRAP
PHOTOCELL GND STRIKE GND KEYP
AD / RDR
GND FIRE DEPT GND MAX OPEN GND RADIO SIG. RADIO GND OPEN STOP CLOSE COM GA
TE DISABLE
MOTOR
ON-LINE
LIMIT
SWITCH
ON-LINE
SAFETY
ANTI
TAILGATE
OFF ON
AUTHORIZED Vehicle
UNAUTHORIZED Vehicle
1
2
When last Safety Loop is cleared, gate will close.
NOTE: If a VALID open command is received at this
point, gate will stop and reopen.
Safety Loop gets activated and PAUSES the closing gate.
Gate will NOT reopen. Vehicle MUST back up for loop to
clear, then gate continues to close. NO unauthorized entry .
NO VALID open command.
OFF
OFF ON
ON
Single Pass Anti-Tailgate
Radio Safety Pause
Mode 0
Gate in Motion Alarms
ON
OFF
ON
OFF
ON
OFF
Mode 1
Mode 1
ON
OFF
Motion Alarm sounds before gate moves and continues until gate stops
Motion Alarms OFF
Beeper Alert sounds in Battery Back-Up Mode while gate is in motion
Beeper Alert OFF
Mode 0
When turned “ON”; After a vehicle clears the Safety Loop, a closing
gate will PAUSE if a second vehicle attempts to tailgate. The second
vehicle must then back off the safety loop for the gate to continue
closing. A new radio signal will open the gate.
When turned "ON" a moving gate will pause if a radio input signal is
received. The next radio signal causes the gate to continue in the
original direction.
MADE IN USA WWW.Max.US.com
OFF
ON
VALID open command was given.
UNAUTHORIZED Vehicle Approaches
NO VALID open command is given.
Vehicle is attempting to activate safety loop
before the gate’s close cycle is complete,
expecting gate to reopen.
SAFETY LOOP
CENTER LOOP
SAFETY LOOP
INSIDE
Property
OUTSIDE
Property
CENTER LOOP
SAFETY LOOP
SAFETY LOOP
MATRIX 1 Back
- Gate Pauses - - Gate Pauses -
LED stays ON
when Anti Tailgate
is ON