RMT55H
20195 South Diamond Lake Road, STE 100
Rogers, MN 55374
800.621-2789
29
7.3
Tine Adjustment
The standard tilling width is 26” with both inner and outer tine assemblies mounted. Tilling width
is 14” with outer assemblies removed.
1.
To remove outer tine assemblies from inner tine assemblies, remove pin clip from clevis
pin.
2.
Slide clevis pin out and remove outer tine assembly.
8
Maintenance
⚠
DANGER:
To avoid possible serious bodily injury, when performing any adjustments, remove
the spark plug wire and place the wire away from the plug to prevent accidental starting.
8.1
Periodic Check
1.
Regularly check all bolts and nuts for tightness.
2.
If the belt begins to bottom out on the engine pulley, then replacement of the pulley is
needed. This is noticeable by the pulley “V” bottom becoming shiny.
8.2
Engine Oil
1.
Check the oil level before starting the engine and after every five hours of operation.
2.
Be sure engine is cool.
3.
Before removing the filer plug, clean the area around it to prevent dirt from entering the
oil fill hole.
4.
The engine should be in a level position when checking the oil.
5.
Remove the filler plug and fill the crankcase with oil.
6.
Use a high-quality detergent oil – refer to your engine owner’s manual for oil
requirements.
7.
Add oil as necessary to keep oil level as indicated. Detergent oils keep the engine cleaner
and reduce the formation of gum and varnish deposits. Nothing should be added to the
recommended oil.
8.
Change the oil after the first 20 hours of operation and every 100 hours there-after or
every 6 months, whichever comes first. Always change oil while the engine is warm. Oil
may be drained through the oil drain port towards the bottom of the engine. Refer to
your Engine Owner’s Manual for complete details.
⚠
DANGER
To avoid possible serious bodily injury, when performing any adjustments, remove the
spark plug wire and place the wire away from the plug to prevent accidental starting.
