MaxID iDLMax, Руководство пользователя

Страница: 13 / 54

C H A P T E R 1
G E T T I N G T O K N O W Y O U R I D L M A X
Product User Guide 3
Power
Charging
Battery Charging & LED Indicators
The battery charger has two LED’s. One LED is to indicate “Power” status and one is to indicate “Charging” status.
The LED’s indicate the following:
When powered on with no battery inserted the “Power” LED illuminates and the “Charging” LED turns on briefly then off again. The
“Power” LED remains on for as long as power is supplied to the battery charger.
On inserting an uncharged battery into the battery charger the “Charging” LED turns on. This indicates that a charge cycle has begun and
the inserted battery is being charged.
When the battery charger detects that the charging battery has reached full charge. The “Charging” LED turns off indicating the charge
cycle has ended and the battery is now fully charged.
On inserting a battery that is already fully charged, the “Charging” LED will remain off to indicate that the battery does not need charging.
Inserting the battery into the iDLMax
Insert the battery into the iDLMax as shown below
At all times - Switch off the iDLMax before removing the battery.
Before using the iDLMax for the first time the removable external batteries MUST be charged. The initial charging cycle for
both batteries is approximately twelve (12) hours. Subsequent charging cycles will take up to a maximum of four and a half
hours.
Using the normal Power down option before removing a battery will ensure that application data are stored savely. If the
battery is removed from the iDLMax or completely discharged during normal operation, there is a window between 40
second to 1 minute and 20 seconds (depending on the charge level of the backup battery) in which to insert a charged
battery or plugging a power supply into the iDLMax, before losing non-persistent application data.
Charging a battery via the iDLMax
The iDLMax was designed to allow the user to charge a battery while it is inserted into the iDLMax. This can be done by simply connecting the
supplied power lead with power supply to the iDLMax.
First, the power lead must be connected into the three-prong connector on the PSU. The
power lead plug must then be connected to a power source and the power source switched on. Now connect the supplied functional PSU into the
iDLMax by plugging the DC Jack into the designated connecter at the back of the iDLMax as per the picture below.