Copyright 2015 by Maxford USA
Page
12
RUMPLER TAUBE / Doc. Nbr. S160113
12.
Use crimp tubes to link 4 preassembled wing warping cable assemblies to their servos as pictured
below.
13.
As shown
below, glue
the truss
supports into
the predrilled
holes on the
bottom of the
wing panels.
14.
Glue the trusses onto the truss supports.
Use clevises
to adjust
cable
tension.
NOTE: DO NOT GLUE either truss to the fuselage
if you want to remove the wings for transport.
NOTE: The truss is approx.
4
1/4
-inches (10.8 cm)
behind the leading edge of
the wing. Set the CG at approx.
3
1/4
- to 4
1/4
-inches (8.3 to
10.8 cm) behind the wing’s
leading edge.
Truss
supports
Truss
