MAXCUT STEALTH-12 OPERATOR’S MANUAL
MAXCUT INC.
Page 15 of 31
MADE IN U.S.A.
4.3.8. Store the saw away from excessive heat or moisture. Store in a clean, dry
area away from exposure to high humidity, water, other liquids, or freezing
temperatures. Avoid temperatures low enough to cause condensation on the
chain when moving it from storage to a higher temperature. Always handle
and store chains carefully.
4.3.9. DO NOT stack material on top of the saw that may cause the chain or bar to
bend or deform.
5. MAINTENANCE
5.1. GENERAL MAINTENANCE RULES
5.1.1. Hydraulic fluid can become contaminated after extended periods of use which
can cause restrictions in the system. Check to see that the fluid is clean, and
change at recommended intervals to extend saw’s life. Refer to the respective
manual for maintenance information on the hydraulic power source.
5.1.2. Proper maintenance of the saw and related equipment requires timely
adhering to all the guidelines given in this chapter. Proper maintenance is
required to maintain the system in good condition and free of defects.
5.1.3. Review and follow all the safety rules given in Chapter 1 before attempting
any maintenance.
5.1.4. Only authorized personnel should be allowed in the maintenance area.
Authorized personnel are the trained people as defined below and their
supervision.
5.1.5. Repairs must be made only by trained personnel. A trained person is one
who has read and thoroughly understands this instruction manual and related
equipment manuals and, through training and experience, has shown
knowledge regarding the safe operational procedures.
CAUTION:
BEFORE STARTING ANY MAINTENANCE, DISCONNECT SAW FROM
HYDRAULIC POWERSOURCE TO PREVENT ACCIDENTAL STARTUP.
WARNING:
DURING ANY MAINTENANCE OR REPAIR PROCEDURES, DO NOT
ATTEMPT ANY SAWING. THIS CAN CAUSE EQUIPMENT DAMAGE
AND/OR PERSONAL INJURY.
5.2. GUIDE BAR MAINTENANCE
5.2.1. Ensure the bar and nose sprocket has a light coat of oil to prevent rusting.
5.3. CHAIN MAINTENANCE
5.3.1. Inspect the chain before mounting and before each use.
5.3.2. Ensure there are no missing segments or bumpers.
5.3.3. Ensure there are no signs of cracking, overheating, or other damage.
5.3.4.
Check the wear of the chain chassis, typically referred to as ―chain stretch‖,
by tensioning the chain as described in Section 3.6. The chain chassis is