Maxcom MC6950, Быстрый старт

Страница: 49 / 53

• Do not try to open the batteries.
• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
• Do not charge non‐rechargeable batteries.
• Ensure the battery compartment panel is secure.
• When replacing used batteries, please comply with applicable regulation relating to their disposal. Please return them to a
suitable collection facility for environmentally friendly disposal.
CAUTIONS
‐ Danger of explosion if battery is replaced by an incorrect type.
‐ Replace only with the same or equivalent type.
USER INSTRUCTIONS
• The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily
accessible.
• The product should not be used when temperature exceeds 35° C.
• Warning: If you do not allow your handset to charge for at least 24 hours prior to its first use, it will not function to its full
capacity.
• The warrantee does not cover malfunction problems caused by the improper charging of handset prior to its first use.
POWER SUPPLY INFORMATION
• Power supply : 230 V ~50 Hz
• Power consumption 0.1W in standby mode
ADDITIONAL INFORMATION
• This product uses audio frequency bands that are standardised throughout the European community.
• The marking of the certified terminal equipment is found under the base unit.
• The SAR test is not required for products whose power is lower than or equal to 20 mW. This product has an average
power level which falling below this level and therefore is not subject to the test.
• This product is compatible only with the internet set up box which are compliant with the PSTN (public switches telephone
network)
• The device must be connected to a power outlet with an AC/DC mains adapter, in compliance with the EN 60950
• The device cannot be connected to an IT power scheme.
• The telephone line jack is in compliance with the security norm TRT‐3.
• The power outlet is in compliance with the security norm TBTS.
• The electrical security corresponds to the EN 60950 specifications.