Maxcom MC6950, Быстрый старт

Страница: 25 / 53

Setting the base unit
Press on handset :
PIN code setting
A 4‐digit system PIN code is used for changing the system settings of the base station. It is used to
protect your phone against unauthorized use. The default system PIN code is 0000.
x 2
Enter in the menu and Select BS SET
x 5
Select CHG PIN
Press MENU / OK to display
OLD PIN?
Enter the old system PIN.
Press MENU / OK to display
NEW PIN? , and enter your new 4‐digit system PIN.
Press MENU / OK to display CONFIRM? , and enter your new 4‐digit system PIN again.
Press MENU / OK to confirm.
Registering a handset to the base unit
IMPORTANT: When you purchase your CDP401 phone system, all handsets are already registered
to your base, so you do not need to register them. Handset registration is only necessary when
you buy extra handsets or if a handset has become faulty.
You can register additional handsets to have up to five handsets per base unit, with each
handset's number (1 to 5) shown on its display.
Each handset can be registered to up to 4 bases, but can only operate with one base at a time.
(See chapter “Select Base”, for how to change between bases.)
To register a new handset to your base:
Press and hold PAGE on the base station for more than five seconds to put the base station
into registration mode. It will stay in registration mode for about 1 minute, so the
following handset sequence must be completed within this time.
x 6
Enter in the menu and Select REGISTER
Press MENU / OK to display BASE 1 .
Press UP / DOWN to select which base number you want to use. (Note: a * will be shown next
or
to any base numbers the handset is already registered with, and if selected the new registration
will overwrite it.)