4–3
OPERATION
www.maxcessintl.com
MAGPOWR DTR-65
MI 850A349 1 D
Programming
mode
Enter the programming menu
Press and hold [+] and [-] for two seconds.
Exit the programming menu
Press and hold [+] and [-] for two seconds.
Also: While showing parameter P.24, you may press [
] to exit
the menu and return to displaying the tension.
Parameter number
While in the programming mode, the display shows P.xx, where
xx is the parameter number.
Press [+] or [-] to increment or decrement the parameter
number. Press [
] to enter the data entry mode for a
parameter. Use [+] or [-] to change the value of a parameter.
Press [
] and release to cancel the data change and return to
the menu. Press [
] and hold for two seconds (until the display
starts flashing) to save the changed parameter. If the data has
been changed and the data has not been saved, after five
seconds of no button activity the display will flash indicating
the data needs to be saved.
The CAL1 and CAL2 menus are sub-menus which are used to
step the operator through the calibration sequence. Press [
]
when a CALx menu is showing to get into the sub-menu. The
parameters will now be labeled Cx.y.
continued
