KK-642.014 Rev.No:1 01.08.12 Page | 14
10.2.4 Test
This function enable us test the relays and sounder outputs.
*** TEST ***
> Relay Test
Sounder Test
------------------------------------------------------------
Exit-Main Menu
10.2.4.1 Relay Test
In the Relay test function, the current status of the relays are monitored at the panel.
*** RELAY TEST***
>
Low Alarm Relay: Active
High Alarm Relay: Not Active
Over-range Relay: Active
Fault Relay: Not Active
-------------------------------------------------------------
Enter
– OK
Exit
– Pre Menu
On this screen, it is possible to select the relay which you may want to test, using arrow buttons. (On the left
‘>’ sign should be next to that relay.) By pressing “Enter” relay is selected. (On the left of the relay ‘<’ sign is
present.) After selecting relay, press
“Up(+)” button to test it.
10.2.4.2 Sounder Test
When you enter the sounder test function, the current condition of the sounders is monitored.
***
SOUNDER TEST***
> Sounder 1:
Active
Sounder 2:
Not Active
------------------------------------------------------------
Enter
– OK
Exit
– Pre Menu
On this screen, it is possible to select the sounder output which you may want to test, using arrow buttons.
(On the left
‘>’ sign should be next to that sounder output.) By pressing “Enter” sounder output is selected.
(On the left of the sounder
‘<’ sign is present.) After selecting sounder output, press “Up(+)” button to test
sounder then press
“Down(-) button to exit from the test.
10.2.5 Configure
By using this function, system operating features are programmed.
***
CONFIGURATION
***
> System
Common Relay Settings
Sounder Settings
Channel Settings
-------------------------------------------------------------
Enter
– Ok
Exit
– Pre-Menu