KK-642.014 Rev.No:1 01.08.12 Page | 13
10.2.3 Calibration
In order to make the calibration of the detectors, this function is used. It composes of 3 sub-functions.
***
CALIBRATION ***
> Calib. Channel.
Calib. Level:
Calibrate
------------------------------------------------------------
Exit
– Pre Menu
First of all the channel which want to be calibrated is selected. To do that the sign
“>” should be in the left
side of the sub-function
“Calib Channel”. Press “Enter”. (The sign “<” will be seen on the right side of the sub-
function
“Calib. Channel). Using “Up (+)” and “Down (-)” buttons channel name is found. By pressing “Enter
Butt
on” the related channel is selected.
After that calibration level shall be adjusted. To do this, again, using
“Up (+)” and “Down (-)” buttons
“Calibration level” sub-function is selected. When you press “Enter” button, on the right side of the
“Calibration Level” text the sign “<” is seen. In this position, calibration level value is adjusted between 25
and 100. To confirm the value press
“Enter Button”.
Once you done with these adjustments, calibration process can be started. For calibration
“Calibrate” sub-
function is selected and then
“Enter” is pressed. In such setting the screen is shown as:
Calibration process gets started by pressing
“Enter” button.
***
CALIBRATION ***
Calibrating channel is inhibited!!!
When get ready press
“Enter”
0
Calibration process gets started by pressing
“Enter” button.
a) IF CALIBRATION NOT SUCCEEDED
***
CALIBRATION ***
Calibrating channel is inhibited!!!
30
Input fault
------------------------------------------------------------
Exit-Ana Menu
b) IF CALIBRATION SUCCEEDED
***
CALIBRATION ***
Calibrating channel is inhibited!!!
50
Calibration has been done
Exit after gas level lowered
