14
2.5 Start input
(M1 signal terminal pin 6)
The standard drive is furnished in this configuration.
Start enable input has logic range: >+9V to +30Vdc (min/max)
Unconnected Enable input = Drive Not Enabled
Enable Input >+9V to +30Vdc = Drive Enabled
Is possible enable the drive connected the START input with +9.8V output „terminal 4“
2.6 Analog inputs (+/-VEL)
(M1 signal terminal pin 7 and 8)
Differential reference
The following diagram shows an application utilizing a differential reference from a C.N.C
The +/-VEL in differential mode has a 40Kohm of impedance input.
Common mode reference
The following diagram shows an application using speed reference connections from C.N.C
in the Common Mode. This analog in common mode has a 20Kohm of impedance input.
The following diagram shows an application utilizing a differential reference from a C.N.C
The +/-VEL in differential mode has a 40Kohm of impedance input.
Speed potentiometer
The following diagram shows an application using speed reference connections from C.N.C in the
Common Mode. This analog in common mode has a 20Kohm of impedance input.
The following figure shows an application with speed reference connections using an in/-9.8V
power supply.
The speed potentiometer must have an included value between >5 and <10Kohm.
In the terminals 4 (+9.8 V) and 5 (-9.8V) are available auxiliary supplies to power the potentiometer
reference speed. In the attached drawing below is also added a switch that allows the reversal of
the rotation motor speed .
The current capacity of the output is max + /-4mA
9.8V can also be used to enable the converter
Is possible enable the drive connected the START input with +9.8V output "terminal 4"
The standard drive is furnished in this configuration.
Start enable input has logic range: >+9V to +30Vdc (min/max)
Unconnected Enable input = Drive Not Enabled
Enable Input >+9V to +30Vdc = Drive Enabled
The following diagram shows an application utilizing a differential reference from a C.N.C
The +/-VEL in differential mode has a 40Kohm of impedance input.
Speed potentiometer
The following diagram shows an application using speed reference connections from C.N.C in the
Common Mode. This analog in common mode has a 20Kohm of impedance input.
The following figure shows an application with speed reference connections using an in/-9.8V
power supply.
The speed potentiometer must have an included value between >5 and <10Kohm.
Содержание MDCA 100
Страница 1: ...1 MDCA XXX XX Precision Servodrive for DC motors...
Страница 2: ...2...
Страница 4: ...4 MDCA XXX XX...
Страница 36: ...36 V 1 0...