GB-21
INSTRUC
TION
M
ANU
AL
FAILURE
PROBABLE CAUSE
SOLUTION
Your machine is vibrating.
There is a small amount of
clothes in the device.
It does not prevent the
operation of the machine.
Excessive amount of clothes
are filled in the machine or
the clothes are not placed in
a well-balanced manner.
Do not exceed the
recommended quantity of
clothes and spread your
clothes in the machine in a
well-balanced manner.
Excessive foam in the
detergent drawer.
Too much detergent has
been used.
Press the Start/Pause button.
In order to stop the foam,
dilute one table-spoon of
softener in half litre of water
and pour it in the detergent
drawer. After 5-10 minutes
press the Start/Pause button.
Arrange the amount of the
detergent properly in the
next washing process.
Wrong detergent has been
used.
Use only detergents
produced for full automatic
machines.
The washing result is bad.
Your laundry is too dirty for
the programme you have
selected.
Select a suitable programme.
(see page 10-11)
The amount of detergent
used is not sufficient.
(follow your detergent
producer’s instructions).
The washing result is not
good.
Clothes exceeding the
maximum capacity has been
filled in your machine.
Put the clothes in your
machine in a manner not
to exceed its maximum
capacity.
Your water may be hard.
(follow your detergent
producer’s instructions).
Distribution of the clothes
in your machine is not well-
balanced.
Spread the clothes inside the
machine in an orderly and
well-balanced manner .
The water is drained from
the machine as soon as it is
filled.
The end of the water drain
hose is in a position too low
according to the machine.
Place the water drain hose in
an appropriate height. (**)
No water is seen in the drum
during washing.
No failure. The water is at the
lower part of the drum.
N/A
(**) See the section concerning installation your machine.
M100WM10E_20100209_without PN.indd 21
